V-TUF XHDM151 HIGH PRESSURE PUMP 170 Bar (2500 PSI); 12 litres per minute, Industrial Pump with 24mm MALE Shaft suitable for electric hollow shaft motors such as the MH.243 to run with a 05 jet or MH.4155 to run with a smaller jet for at pressures closer to 170 Bar . The flow rate of 12 litres per minute is suitable for most water mains supplies. The V-TUF XHDM151 comes without unloader valve. This pump MUST be fitted with an unloader valve KITS such as: C0.063 or C0.194 (see IMPORTANT safety notice below).
- 2 x Inlet 1/2F bsp ports – one ½F bsp port is supplied with a blanking plug
- 2 x Outlet 3/8F bsp ports - one ½F bsp port is supplied with a blanking plug
- The XHDM151 pump comes lubricated complete with V-TUF PRESSURE LUBE PL500.
The XHDM151 PUMP has been used on the VTUF240 ; VTUF110 ; RAPID VSC HOT pressure washers.
SERVICE KITS (see images above)
- VALVE2A Valve kit
- PISTON2A Piston kit
- N601-327BSFW Pump head bolt kit
- VTPSBR01 Oil filler & Breather plug
- SEAL2A Water seal kit
- O.SEAL2A Piston Oil seal
- 2745 Support ring kit
- PL500 Pump lubricant (oil) PL500
Note: the pressure must be set to unload at no more than 170 BAR (2500PSI). See safety note below:
IMPORTANT SAFETY NOTE: BEFORE powering the system: 1. the unloader valve MUST be set at MINIMUM pressure; 2. The bypass port MUST be open; 3. Then set the unloader to the required pressure (which MUST be LESS than the maximum unloader pressure of the unloader valve AND LESS than the maximum pressure of your equipment); 4. Set the locking nuts so this pressure (the running pressure and the lock line pressure) cannot be exceeded.
CAUTION: This is high pressure equipment and if the above safety and set up rules are not followed, serious damage to equipment and injury to humans can occur. The caps and joints can be blown clean out of their threads which cause dangerous projectiles. Please be free to ring 01522 787978 if you need any assistance.
