250 Bar (3600 PSI) max pressure rated Industrial PUMP and GEARBOX with 1" Shaft suitable for 1" horizontal shaft engines such as Loncin VLCP15 and HONDA GX240 ; GX390 and VLCD10 and YANMAR diesel engines. The pump is low revving which decreases wear. The flow rate is 15 litres per minute. The XHD400SS-GBKIT2 comes complete with detachable unloader valve with 2m return to tank bypass which prevents the pump from overheating when running in bypass. The pump inlet is 1/2F BSP thread (a filter such as the is recommended); the pump outlet is 3/8M thread.
Recommended replacement pump for the Interpump 59 series E3B2515 pump on Belle Bowser pressure washers.
- Note: the pressure must be set to unload at no more than 250 BAR (3600PSI). See safety note below:
- The XHDM400SS pump and gearbox comes lubricated complete with V-TUF PRESSURE LUBE PL500.
Recommended EXTRAS:
- P13.6511AL Pump inlet filter
- E1.1013KIT PUMP SUCTION KIT (3m)
- PL500 V-TUF Pressure Lube (for pump top up)
- MB8/MB12/NP Pump inlet fitting
SERVICE KITS:
100% manufactured in the EU which give you the confidence that all materials and design are to give you the greatest return on your investment.
Most mains water supplies cannot cope with 15.7 litres so it may be advisable to run these units on suction out a water butt if you are unsure.
- The V-TUF XHDM400SS - GBKIT2 MUST have the unloader set as shown below before operation.
- 2 x Inlet 1/2F bsp ports – one ½F bsp port is blanked
- 2 x Outlet 3/8F bsp ports - one ½F bsp port is supplied with a blanking plug
- OPTIONAL EXTRAS: PL500 V-TUF Pressure Lube (for pump top up)
- Suitable alternative/replacement for the following pumps: INTERPUMP WS201 , V-TUF VT301 ; AR RK 15.20H ; V-TUF XHDM400
- Note: the pressure must be set to unload at no more than 200 BAR (3000PSI). See safety note below:
IMPORTANT SAFETY NOTE: BEFORE powering the system: 1. the unloader valve MUST be set at MINIMUM pressure; 2. The bypass port MUST be open; 3. Then set the unloader to the required pressure (which MUST be LESS than the maximum unloader pressure of the unloader valve AND LESS than the maximum pressure of your equipment); 4. Set the locking nuts so this pressure (the running pressure and the lock line pressure) cannot be exceeded. - CAUTION: This is high pressure equipment and if the above safety and set up rules are not followed, serious damage to equipment and injury to humans can occur. The caps and joints can be blown clean out of their threads which cause dangerous projectiles. Please be free to ring 01522 787978 if you need any assistanc
